REWEAR

Buying

Buying a second-hand puffer jacket: down, loft and leaks

How to judge a used puffer from photos and the care label: down or synthetic, fill power, flat spots, leaking feathers, smells, and what can be put right.

A second-hand puffer or down jacket is a good buy when every section is still evenly full, nothing is leaking feathers through a hole, the zip runs from top to bottom, and the cuffs, collar and hem are clean. The care label tells you the fill: down, a down and feather mix such as 80/20, or synthetic. Ask how it has been washed and dried, because a puffer treated the wrong way comes out flat and lumpy, though with down that can often be put right.

What the label tells you about the fill

Ask for a photo of the care label if the listing does not show it.

  • Down and feather ratio: the first number is the down, the second the feather, so 90/10 is lighter and warmer for its weight than 80/20. Mostly feather is heavier and less lofty.
  • Fill power: a number such as 600 or 800, sometimes printed on the label or a sleeve tag. It measures how much space the down fills, so higher means more warmth for its weight. Around 600 to 700 is good for everyday wear; 800 and above turns up in light, packable outdoor jackets. Brands measure it slightly differently, so compare like with like.
  • Synthetic fill: keeps more warmth when damp and is easier to wash, but is a little heavier for the same warmth, and it slowly loses its spring after years of squashing.

Fill power is about quality, not total warmth: a thin 800-fill jacket can be colder than a thick 600-fill one, so look at how full the jacket is as well as the number.

The loft test: flat spots and lumps

Puffers are stitched into sections, called baffles, that keep the fill spread out. With wear, or after a bad wash, the fill can clump or thin. Ask for one photo of the jacket laid flat and one of it hanging, in daylight, and look for:

  • flat sections, especially across the shoulders and back, where bag straps and car seats press;
  • lumps, where the fill has clumped in one corner of a section;
  • one side puffier than the other.

A flat down jacket is often fixable: a proper wash and a long, low dry can bring the loft back. A flat synthetic one usually stays flat.

Tip

If the care label allows tumble drying, clumped down can be broken up by drying on low heat with two or three clean tennis balls. It cannot replace fill that has escaped.

Leaks, tears and smells

  • A feather poking through is normal on down now and then. Pull it back in from the inside rather than out, then rub the spot to close the weave.
  • Feathers escaping from one place usually mean a small hole. A self-adhesive nylon repair patch fixes most small ones; a long tear needs a proper repair.
  • Seams between sections: look for pulled or broken stitching.
  • Smell: a musty or wet-animal smell suggests the down was put away damp or never dried fully. A careful wash and a very thorough dry often clears it, but it is worth asking about first.

On Rewear, sellers can tag flaws such as a small hole, a repair or "Smells of smoke or damp", and show the visible ones close up. Where Rewear's photo check spotted a flaw, the listing shows which photo it is in.

Zip, hood and wear points

Ask whether the main zip runs smoothly all the way and whether a two-way zip opens from both ends; our guide to fixing a stuck zip shows the easy fixes. Check pocket zips and poppers, and whether a detachable hood or faux fur trim is included. Then look at the cuffs and hem for grubby edges, and inside the collar and chin guard for make-up marks; our guide to removing make-up from collars shows what shifts them.

Fit, briefly

A puffer goes over other layers and the fill takes up room inside it, so compare the listing's chest, length, sleeve and shoulder with a coat you wear over a jumper. Double the pit-to-pit chest for the measurement all the way round. Our guide to how a puffer jacket should fit covers layers, sleeves, hem and hood.

What sets a fair price

Brand, fill and condition decide most of it. A lofty down jacket with a clean shell is worth more than a flat or patched one, and a flat synthetic should be priced as it is, since it rarely recovers. Check the grade against the photos: Very good means worn with no flaws, Good minor signs of wear. If it needs a patch or a careful wash, an offer that allows for it is fair.

Three questions to send the seller first:

  1. How has it been washed and dried?
  2. Are feathers coming through anywhere, and where?
  3. Does it smell of anything, and how has it been stored?

When it arrives

Shake it out and give it a few hours to recover from the parcel before you judge the loft. Then try it on and check it against the listing before you confirm delivery in the app: confirming is what pays the seller. Anything wrong that the listing did not mention can be reported on the order within 14 days of delivery. When it needs a wash, our guide to washing a down jacket shows how.

The short version

Read the label for the fill, the ratio and the fill power. Look for flat spots, lumps and escaping feathers in photos taken flat and hanging, and ask about washing and smells. A flat down jacket can often be revived; a flat synthetic one usually cannot.

Find your next piece

Second-hand clothing from sellers across the UK, with measurements in cm where sellers add them and buyer protection at checkout.

See what’s for saleSell on Rewear

More from the Rewear blog